Roland RD-700SX - Changing the Tone for a Zone

40
Performing with the Keyboard
When changing the tone assigned to a zone, use the ZONE SELECT button to specify
the zone with the tone you want to change.
fig.Q1-20p
1
Press the ZONE SELECT button for the part whose tone you want to
change, causing the zone’s indicator to light up.
The indicator for the currently selected TONE SELECT button lights up in the same
color as the indicator for the selected zone.
2
Select the tone category with a TONE SELECT button, then press
[INC]/[DEC] to select the tone.
When [NUM LOCK] is on, you can specify tone numbers with the TONE SELECT
buttons (p. 34).
Changing the Tone for a Zone
2
1
When you press the ZONE
SELECT button corresponding
to a zone for which the ZONE
SWITCH is OFF (unlit), the
three buttons for that zone,
ZONE SWITCH, ZONE
SELECT, and ENTER, start
flashing. Pressing any of these
flashing buttons then sets that
zone’s ZONE SWITCH to ON
(lit).
RD-700SX_e.book 40 ページ ２００６年３月２３日 木曜日 午後２時５２分