62
Using the RD-700SX As a Master Keyboard
When you have finished connecting the external MIDI device, match the keyboard’s
Transmit channel and the Receive channel for each of the external MIDI sound
generator’s Parts. Sounds is produced when the MIDI channels for the sending
device (the RD-700SX) and the receiving device (the external MIDI sound generator)
are set to the same MIDI channel.
fig.Q3-03p
1
Press [EXTERNAL/INTERNAL], getting the indicator to light.
The EXTERNAL screen appears.
If “Ch” doesn’t appear on screen, press CURSOR [ ] several times to display the
following screen.
fig.Q3-03g
2
Press CURSOR [ ]/[ ]/[ ]/[ ] to move the cursor, then press
[INC]/[DEC] to set the Transmit channel (Ch) for each part.
MIDI Send Channel Settings
Part
Parameter Settings Description
UP1 (UPPER1)
Ch
(MIDI OUT
Channel)
1–16 RD-700SX perfor-
mance data is sent
over a selected chan-
nel.
UP2 (UPPER2)
LW1 (LOWER1)
LW1 (LOWER2)
1
2
For instructions on setting each
of the external MIDI sound
generator’s Part’s Receive
channel, refer to the owner’s
manual for each device.
When Rec Mode is set to ON in
the Utility Rec Setting in Edit
mode, the EXTERNAL screen
as shown to the left is not
displayed. Set Rec Mode to
OFF when setting the MIDI
Transmit channel (p. 101).
Part names for Parts in which
ZONE SWITCH is set to OFF
appear in the display in
lowercase letters, such as
“up1,” “up2,” “lw1,” and
“rw2.”
MIDI messages for
Parts with the ZONE
SWITCH set to OFF are not
transmitted.
RD-700SX_e.book 62 ページ ２００６年３月２３日 木曜日 午後２時５２分
To Next Page
Loading...
