Roland RD-800 - Tone Customization with Designer; Tone Designer Overview and E. Piano Settings; Clav and Other Tone Settings

33
Tremolo/Amp Simulator Parameters
3: E. PIANO
Overdrive Tremolo
L in
R in
2-Band
EQ
L out
R out
Speaker
Parameter Value Explanation
Bass -50–+50 Gain of the low range
Treble -50–+50 Gain of the high range
Tremolo Switch OFF, ON Tremolo on/o
Tremolo Type
OLDCASE MONO,
OLDCASE
STEREO,
NEWCASE,
DYNO,
WURLY
Type of tremolo eect
Tremolo Speed
(sync sw)
OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Tremolo Speed
(Hz)/
Tremolo Speed
(note)
0.05–10.00 [Hz]
Rate of the tremolo eect
note (p. 31)
Tremolo Depth 0–127 Depth of the tremolo eect
Tremolo Shape 0–20 Adjusts the waveform of the tremolo.
AMP Switch OFF, ON
If this is o, speaker and overdrive are
not applied.
Speaker Type
LINE,
OLD,
NEW,
WURLY,
TWIN
Type of speaker
* If LINE is selected, the sound will
not be sent through the speaker
simulation.
OD Drive 0–127 Degree of distortion
Level 0–127 Output Level
Characteristics of the tremolo types
Tremolo types of diering character are available, allowing you to
reproduce the character of classic electric pianos when combined
with an electric piano sound.
Type Explanation
OLDCASE MONO
Used in conjunction with TINE EP, this simulates an early
model of a classic electric piano of the 60s.
OLDCASE
STEREO
Used in conjunction with TINE EP, this simulates a classic
electric piano sound of the early 70s.
NEWCASE
Used in conjunction with TINE EP, this simulates a classic
electric piano sound of the late 70s and early 80s.
DYNO
This model allows you to vary the shape of the tremolo
waveform.
Used in conjunction with TINE EP, this simulates an electric
piano sound used in many recordings of the early 80s.
WURLY
Used in conjunction with REED E. PIANO, this simulates a
classic electric piano sound of the 60s.
4: GUITAR AMP
Pre Amp Tremolo
L in
R in
L out
R out
Speaker
Parameter Value Explanation
Pre Amp Switch OFF,ON Turns the amp switch on/o.
Pre Amp Type
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD,
MS1959I,
MS1959II,
MS1959I+II,
SLDN LEAD,
METAL 5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION,
FUZZ
Type of guitar amp
Pre Amp Volume 0–127
Volume and amount of distortion of
the amp
Pre Amp Master 0–127 Volume of the entire pre-amp
Pre Amp Gain
Low,
Middle,
High
Amount of pre-amp distortion
Pre Amp Bass 0–127 Tone of the bass/mid/treble frequency
range
* Middle cannot be set if “Match Drive”
is selected as the Pre Amp Type.
Pre Amp Middle 0–127
Pre Amp Treble 0–127
Speaker Switch OFF, ON
Selects whether the sound will be
sent through the speaker simulation
(ON) or not (OFF)
Speaker Type
SMALL 1,
SMALL 2,
MIDDLE,
JC-120,
BUILT-IN 1,
BUILT-IN 2,
BUILT-IN 3,
BUILT-IN 4,
BUILT-IN 5,
BG STACK 1,
BG STACK 2,
MS STACK 1,
MS STACK 2,
METAL STACK,
2-STACK,
3-STACK
Type of speaker
Tremolo Switch OFF, ON Turns the tremolo eect on/o
Tremolo Mod
Wave
TRI,
SQR,
SIN,
SAW1,
SAW2,
TRP
Modulation Wave
TRI: triangle wave
SQR: square wave
SIN: sine wave
SAW1/2: sawtooth wave
TRP: Trapezoidal wave
Tremolo Rate
(sync sw)
OFF, ON
If this is ON, the modulation is
synchronized to the tempo of the
rhythm (owner’s manual p. 24).
Tremolo Rate
(Hz)/
Tremolo Rate
(note)
0.05–10.00 [Hz]
Rate of the tremolo eect
note (p. 31)
Tremolo Depth 0–127 Depth of the tremolo eect
Level 0–127 Output Level