34
Tremolo/Amp Simulator Parameters
Specications of each Speaker Type
The speaker column indicates the diameter of each speaker unit
(in inches) and the number of units.
Type Cabinet Speaker Microphone
SMALL 1
Small open-back
enclosure
10 Dynamic
SMALL 2
Small open-back
enclosure
10 Dynamic
MIDDLE
Open back
enclosure
12 x 1 Dynamic
JC-120
Open back
enclosure
12 x 2 Dynamic
BUILT-IN 1
Open back
enclosure
12 x 2 Dynamic
BUILT-IN 2
Open back
enclosure
12 x 2 Condenser
BUILT-IN 3
Open back
enclosure
12 x 2 Condenser
BUILT-IN 4
Open back
enclosure
12 x 2 Condenser
BUILT-IN 5
Open back
enclosure
12 x 2 Condenser
BG STACK 1 Sealed enclosure 12 x 2 Condenser
BG STACK 2
Large sealed
enclosure
12 x 2 Condenser
MS STACK 1
Large sealed
enclosure
12 x 4 Condenser
MS STACK 2
Large sealed
enclosure
12 x 4 Condenser
METAL STACK
Large double
stack
12 x 4 Condenser
2-STACK
Large double
stack
12 x 4 Condenser
3-STACK Large triple stack 12 x 4 Condenser
5: ROTARY
Overdrive Rotary
R in
L out
R out
Parameter Value Explanation
Speed SLOW, FAST
Simultaneously switch the rotational
speed of the low frequency rotor and
high frequency rotor.
SLOW: Slows down the rotation to the
Slow Rate.
FAST: Speeds up the rotation to the
Fast Rate.
Rotary Switch OFF, ON
Switches the rotation of the rotary
speaker.
When this is turned o, the rotation
will gradually stop.
When it is turned on, the rotation will
gradually resume.
Woofer Slow
Speed
0.05–10.00 [Hz]
Slow speed (SLOW) of the low
frequency rotor
Woofer Fast
Speed
0.05–10.00 [Hz]
Fast speed (FAST) of the low frequency
rotor
Woofer Trans Up 0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Slow to Fast.
Woofer Trans
Down
0–127
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Fast to Slow.
Woofer Level 0–127 Volume of the woofer
Tweeter Slow
Speed
0.05–10.00 [Hz]
Settings of the tweeter
The parameters are the same as for
the woofer.
Tweeter Fast
Speed
0.05 - 10.00 [Hz]
Tweeter Trans Up 0–127
Tweeter Trans
Down
0–127
Tweeter Level 0–127
Spread 0–10
Sets the rotary speaker stereo image.
The higher the value set, the wider the
sound is spread out.
Low Gain -15–+15 [dB] Gain of the low range
High Gain -15–+15 [dB] Gain of the high range
Level 0–127 Output Level
OD Switch OFF, ON Overdrive on/o
OD Gain 0–127
Overdrive input level
Higher values will increase the
distortion.
OD Drive 0–127 Degree of distortion
OD Level 0–127 Volume of the overdrive
To Next Page
Loading...
