Roland S-1

Editing the notes, performance data and motions
42
When you long-press a step pad that contains a tie, the note number inputted to that step is shown in the display.
You can’t input a tie if a note already exists in the next step.
Deleting all notes at once within a specified step
1. Hold down the [SHIFT] button and press pad [11] (CLEAR NOTE).
“CLr.n” blinks in the display, and the unit waits for you to execute or cancel.
2. To execute, press pad [2] (ENTER).
If you decide to cancel, press pad [1] (EXIT).
Inputting a motion into a specified step
1. Use the [TEMPO/VALUE] knob to select the step to edit.
2. Turn the knob to register a motion.
“FULL” is indicated if the number of parameters exceeds the maximum number that can be registered in a motion.
If this happens, follow the steps in “Deleting all motions from a specified step at once” to delete any unnecessary motions.
Deleting all motions from a specified step at once
1. Use the [TEMPO/VALUE] knob to select the step to edit.
2. Hold down the [SHIFT] button and press pad [12] (CLEAR MOTION).
“CLr.N” blinks in the display, and the unit waits for you to execute or cancel.
When the unit is waiting for you to execute or cancel, you can delete only the parameter for a specific knob from a motion by
turning that knob. (This is executed when you turn the knob.)
3. To execute, press pad [2] (ENTER).
If you decide to cancel, press pad [1] (EXIT).