Roland S-1 - Copying, Initializing and Reloading a Pattern

Copying, initializing and reloading a pattern
48
Copying, initializing and reloading a pattern
Copying the patterns
Copies the current pattern to a specified pattern.
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select “COPY”, and press pad [2] (ENTER).
3. Use the [TEMPO/VALUE] knob to select the copy destination number.
4. To execute, press pad [2] (ENTER).
To cancel, press pad [1] (EXIT).
Initializing a pattern
This shows how to initialize the currently selected pattern (sequence and tone).
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select “init”, and press pad [2] (ENTER).
The pattern you initialized returns to its previous state once you turn off the power.
To save the pattern, follow the steps in “Saving a pattern(P.47)”.
Reloading a pattern
This shows how to restore the currently selected pattern to its last saved state.
Reload all of the pattern (Reload All)
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select “rLod”, and press pad [2] (ENTER).
Reload the tone (Reload Sound)
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select “rL.Sd”, and press pad [2] (ENTER).
Press the [SHIFT] button, pad [1] (EXIT) and the [POLY] pad at the same time to reload the sound.
Reloading the sequence (Reload Sequence)
1. Hold down the [SHIFT] button and press pad [15] (MENU).
2. Use the [TEMPO/VALUE] knob to select “rL.Sq”, and press pad [2] (ENTER).