Roland SolJet PROII SC-540 - Interface Specifications; Network Interface Specifications

115
Chapter 7 - Appendix
221 kg (487.2 lb.)
Temperature: 15 to 32°C (59 to 89.6°F), Humidity: 35 to 80% (non-condensing) (*3)
Temperature: 5 to 40°C (41 to 104°F), Humidity: 20 to 80% (non-condensing)
power cord : 1, arm (Right) : 1, arm (Left) : 1, stand leg : 1, casters : 2, shafts : 2, bolts (Large) : 22,
bolts (Small) : 8, washers : 6, hexagonal wrench : 1, pipe : 1, media flanges : 2, stoppers : 2, blade : 1,
blade holder : 1, transport bars : 2, drain bottle : 1, bottle stand : 1, Software RIP : 1, user's manual : 1,
replacement blade for separating knife : 1, Roland-PrintServer CD-ROM : 1, Roland PrintServer Net-
work Settings Guide : 1, SOL INK Cleaning cartridges : 4, cleaning kit : 1 (cleaning sticks : 10,
tweezers : 1, wipers : 2)
Packed weight
Environment Power on
Power off
Included items
(*1) The following conditions must be satisfied:
- Media type: 3M Scotchcal Mastercut Film
- Roll media must be loaded on the shaft
- Side margins: 25 mm (1 in.) or more for both the left and right margins
- Front margin: 35 mm (1-1/8 in.) or more
- The required length for cutting must be pulled out from the roll
(*2)
- Temperature : 25 °C (77°F)
- Media type : SV-G-1270G
- Data size : 3,000 mm in the media-feed direction
1,000 mm in the carriage-movement direction
- The required length for cutting must be pulled out from the roll
- No lamination
- When reloading media, at the menu, select [BASE-ALIGN] to automatically detect crop marks.
- Excludes the effects of slanted movement and of expansion and contraction of the media.
(*3)Environment
80
55
35
15
27
32
Humidity
%
(no condensation)
( 59 )
°C (°F)
(
89.6 )
Temperature
(
80.6 )
Use in an operating
environment in this
range.
Interface Specifications
Network Interface Specifications
10Base-T/100 Base-TX Ethernet network cable specifications
Data
Max. cable lenght
Cable type
Impedance
Connector type
Values
100 m
S/UTP Type "category 5"
100 Ohm
RJ-45
Standard
Input signals
Output signals
Level of input output signals
Transmission method
Bidirectional parallel interface (compliant with IEEE 1284: ECP mode (non compression))
STROBE (1BIT), DATA (8BITS), SLCT IN, AUTO FEED, INIT
BUSY (1BIT), ACK (1BIT), FAULT, SLCT, PERROR
TTL level
Asynchronous
7-1 Specifications