55
Chapter 2 - Basic Operation
Aligning Automatically
Read the four crop marks and perform alignment for printing and cutting.
1
Reload the media.
Press the [SETUP] key to display the top
screen.
2
Move the center of the blade to a position over
the lower-right crop mark (the base point), then
press the [AUTO ALIGN] key.
The screen shown in the figure appears.
3
Use the [ ] and [ ] keys to choose [BASE
ALIGN], then press the [ENTER] key.
The four crop marks are read automatically. After the
reading operation has finished, a beep sounds.
4
Send the cutting data.
Cutting starts.
W 1234 mm L ----- mm
Top menu
Alignment cannot be performed if the line connecting the left
and right crop marks is slanted by 5 degrees or more. Adjust
the positioning of the loaded media.
Within 5 degrees
AUTO ALIGN
BASE - ALIGN
Crop mark
Blade
In the automatic-detection operation, media feed continues until crop
marks are detected. If the crop marks could not be detected auto-
matically, follow the steps below.
Stopping Operation Manually
1. Press the [PAUSE] key. The screen shown in the figure appears.
2. Press the [ENTER] key.
Auto-stop Feature
If crop marks are not detected after 3 m (9.8 ft.) of media have been
fed out, detection is paused and the screen shown in the figure is
displayed. If you want to quit detection, press the [ENTER] key. If
you want to output something that is 3 m (9.8 ft.) or longer, then
press the [PAUSE] key to continue detection.
If you’re using dye-based inks, Aligning Automatically is not possible. Follow the steps in “Aligning Manually” on the next
page.
CANCEL CROPMARK
DETECTION?
2-7 Reloading the Media and Performing Cutting
To Next Page
Loading...
