Roland SolJet PROII SC-540 - Installing the Blade; Installing a Blade

32
Chapter 1 - Getting Started
Do not touch the tip of the blade with your fingers.
Doing so may result in injury, and the cutting performance of the blade will be impaired.
1-6 Installing the Blade
Installing a Blade
1
Insert a blade into the blade holder until it snaps
into place with an audible click.
2
Adjust the amount of blade extension as shown
in figure to find the optimal amount of blade for
the target material.
3
Press the [MENU] key, and press the [ ] key
to make the following screen appear on the dis-
play.
4
Press the [ENTER] key to make the following
screen appear on the display.
When the screen shown in the figure appears, the print-
ing carriage simultaneously moves to the left.
5
Open the front cover, loosen the screw in the
figure.
Blade holder
Blade
Max. : 2.5 mm
(0.0984 in.)
0.1mm
Push-pin
Min. : 0 mm
(0.00394 in.)
MENU
REPLACE KNIFE
FINISHED ?
Screw
The amount of
blade extention
Do not leave the tool mounting screws tightened. Tightening the screw makes it more difficult to install the blade holder.