Roland SolJet PROII SC-540 - Bidirectional Correction

66
Chapter 3 - A Wide Variety of Operations
3-5 Making Corrections for Printing
Bidirectional Correction
This adjusts for misalignment that occurs during bidirectional printing. Perform adjustment for bidirectional correction
in situations such as the following.
• When media is replaced with a different type
• When the head height has been adjusted
• When using in a location subject to large changes in temperature
Setting Adjustment Value
1
Press the [MENU] key, and press the [ ] key
to make the following screen appear on the dis-
play.
2
Press the [ ] key to make the following screen
appear on the display.
3
Press the [ENTER] key to start printing a test pattern.
After the printing test has finished, the media is fed to a position that lets you to view the test pattern.
4
Check the test pattern and choose adjustment
value (a value with no displacement).
5
Check the adjustment value, then press the [ENTER] key.
The media returns to its position when the printing test ended.
Bidirectional correction is enabled only when performing bidirectional printing.
+10+9+8+7+6+5+4+3+2+10
-1
-2
-3
-29
-30
H1
H2
H3
H6
H5
H4
NO.2
+10+9+8+7+6+5+4+3+2+10
-1
-2
-3
-29
-30
H1
H2
H3
H6
H5
H4
NO.1
NO.3
NO.4
+10+9+8+7+6+5+4+3+2+10
-1
-2
-3
-29
-30
H1
H2
H3
H6
H5
H4
+10+9+8+7+6+5+4+3+2+10
-1
-2
-3
-29
-30
H1
H2
H3
H6
H5
H4
Adjustment value
(The value with no
displacement)
MENU
ADJUST BI-DIR
ADJUST BI-DIR
TEST PRINT
+10+9+8+7+6+5+4+3