Roland SolJet PROII SC-540 - Step 4: Remove the Protective Media

25
Chapter 1 - Getting Started
1-3 Assembling and Installing
Step 4: Remove the Protective Media
The protective media shown below is attached to this machine when it is shipped from the factory. When you have
finished installing the machine, remove all protective media.
Front
2) Peel off the tape.
4) Remove the retainer.6) Peel off the tape. 5) Peel off the tape, and
remove the packing.
3) Peel off the tape,
and remove the
packing. (Pull straight
back toward you to
extract.)
7) Attach the retainer you removed in step 4).
Rear
Retainer
1) Remove packings.
Packing
Packing
If the screw for the retainer is difficult to
loosen, use a screwdriver to remove it.