42
Chapter 2 - Basic Operation
10
Close the front cover.
Use the [ ] and [ ] keys to select [ROLL],
then press the [ENTER] key.
11
Press the [SETUP] key.
This detects the width of the media and displays the print-
able width.
If a pinch roller is positioned over an area where is no grit
roller, the message shown at below appears when you press
the [SETUP] key. Check the positioning of the pinch roll-
ers and make sure they are aligned at the correct posi-
tions.
If cutting is to be performed from the edge of the media, select [EDGE] (If [EDGE] does not appear, set [EDGE SENSE]
to [ENABLE]).
W 1234 mm L ----- mm
Top menu
The SETUP LED lights up
or [RIGHT]
PINCHROLL ERROR
INVALID LEFT POS
When the machine will remain unused for an extended period, remove roll media from the machine and store it.
If roll media is left mounted on the machine for an extended period, these entire roll may warp, resulting in poor printed image
quality or motor errors.
SETUP SHEET
ROLL EDGE PIECE
2-3 Loading Media
To Next Page
Loading...
