Roland SUPER JX - Functions of the Control Knobs

12
2. Functions of the Control
Knobs
The following controls can be operated even while
you are playing the JX-10.
a. Control Assign Knob @
Each of these two knobs can be used for control-
ling the performance control function you select
with the Control Assign Button. (See page 14 “3.
Control Assign”.)
b, Bender Lever @
This Bender Lever can be used during live perfor-
mance for creating guitar’s chocking-like effect.
The left and right extremes of movement create
the same amount of pitch bending effect. The
maximum effect of the bender can be selected
with the Bend Range Switch: major 2nd, minor
3rd, major 3rd or perfect 5th higher or lower.
Pushing this lever forward will create the vibrato
effect. When the tone you are using has already
taken in a vibrato effect, the effect will be deepened.
c. Aftertouch Fine Adjust Knob @
The Aftertouch effect is the sound's alteration
obtained by pressing the key stronger after playing
it in a normal manner. The JX-10's aftertouch
effect works on the Vibrato, Brilliance and Volume.
Vibrato; The dpeth of the vibrato effect is
deepened.
Brilliance: The tone will become brighter.
Volume: The volume of the sound will increase.
The setting of On/Off or value of each aftertouch
effect can be written in each Patch Memory inde-
pendently, but the Aftertouch Fine Adjust Knob
allows even more delicate adjustment of the
effect. When this knob is set to the center position,
the same effect as set in the Patch Memory can be
obtained, and no effect is obtained at the lowest
position [—].
* Different On/Off settings and values of the after-
touch and bender are written in each of the 64
Patch Memories. Therefore, those effects you
acturally gain will greatly differ depending on
how these are set in the Patch Memories: No
effect may be obtained in some particular
settings.