Roland SUPER JX - Edit

24
6. Edit
The Tones and Patch Memories written in the
JX-10’s internal memory or in the cartridge mem-
ory can be edited to your taste. This editing does
not automatically rewrite the previous data. To
write the edited data, take an appropriate writing
procedure as explained on page 41.
fe BURL BETUNE KKK
a. Editing a Patch Memory
Each of the A-1 to H-8 Patch Memories consists of
39 different Factors and changing the values of the
Factors will edit a Patch Memory. Editing is quite
simple; the value of each Factor has two figure
number, so use the appropriate number to call the
Factor whose value you wish to change then
change it.
This Factor determines the volume balance
of the Upper and the Lower. When the vaiue
is about 50, the volumes of the both sections
are the highest, and as the value increases,
the Lower volume decreases, the Upper vol-
ume remaining the highest. That is, when the
value in the Display is 99, only the Upper
sound will be heard. When the value is smaller
than 50, the opposite effect will be obtained.
This Factor can detune the Lower sound from
the Upper sound. At “+” value, the Lower
sound is raised, at zero, the pitch is the same
as the Upper, and at “~—” value, it is lowered.
—50 to 00 to +50
£1 to G7
15 PORTAMENTO TIME RR
00 to 99
The Split Point set with the Quick Edit is
restricted to the lowest note of the Upper sec-
tion. Here, however, these two Factors are
used for setting two different Split Points;
the lowest note of the Upper section, and the
highest note of the Lower section. The vaiue
and the note name. The lowers note is E1, the
middle C is C4 and the highest is G7. (“+”"
indication represents #.)}
This Factor adjusts the Portamento time.
Higher value is the longer Portamento time.