Roland SUPER JX - Page 35

MIXER
Parameter
ie]
is) ° = Cc o < o
a
atom haT TT MT
to pean Ah Ue H
aaa ceoorereceamanee’ Tm
DCO-2 Level i
| eee SION. OEY Ie rTP NPS
mam
La
Lois nha T ow Ti MEE
1 reat rawr
DCO-2 Envelope Mode uv f
es Re)
&
VCF (Voltage Controlled Filter)
This is where the volume balance of the DCO-1 and
DCO-2 is controlled.
Function Programmer
This adjusts the level of DCO-1.
This adjusts the level of DCO-2.
When ENV controls the DCO-2’'s level, this sets the
amount of ENV signal.
When the DCO-2's level is controlled by ENV
Depth and then by Dynamics, this sets the sen- ay
sitivity of the Key Touch. [NOTE 1]
Normally, “\ is used, and in W mode, ADSR
pattern will be inverted.
:ENVION rie
ENV 1 ™
ed
:ENV2 &
:ENV2 WV
The output signal goes to the Mixer then to the VCF
to be filtered. Each VCF lets lower frequency har-
monics pass and cuts off the higher ones. In other
words, it is a usual low pass filter. By controlling
the cutoff point and resonance, the waveform
changes, thereby the tone color alters.
Parameter
Display
Lata Pe
rrr? roe
High-pass Filter
Cutoff Frequency
Sey ee Se
Se vue PRE wy
Co -s Py ty
Cutoff Frequency
Function Programmer
The HPF (High-Pass Filter) is a filter that passes =
higher frequency harmonics and cuts off the lower a.
ones, As you increase the value, cutoft point goes e
up, lower frequency harmonics being cut off. a
This is for changing the cutoff point of the VCF. As eier
FRED
you decrease the value, cutoff frequency will come
down, and the waveform gradually becomes approx- 10
imation of a sine wave, then the sound will fade out.
35