Roland SUPER JX - Page 44

1) How to call the Patch Memory to be named
@ Call the Patch Memory to be named with the
Patch Memory Buttons.
@ Push the PATCH then the NAME of the Edit
Buttons. Then go to the 3) Naming Procedure”.
@ Patch Name Display
¥ A dot lights up at the first letter of the Patch Name
Available range for a Patch Name
2) How to call the Tone to be named
@ Call the Patch Memory which has the Tone to
be named, using the Patch Memory Buttons.
@ Select either of the Upper or Lower Tone by
using the Upper/Lower Button.
@ Push the TONE then the NAME of the Edit
Buttons. Then go to “3) Naming Procedure”.
@ Tone Name Display
(CO )
Available range for a Tone Name
3) Naming Procedure
In the Display you will see a dot at the Jower right
corner of the letter in the left end of the name. We
call this dot cursor. You can change the letter that
has the cursor at its lower right corner.