Roland SUPER JX - Page 59

3) Program Change ON/OFF
The Program Change ON/OFF function can select
whether to use Program Change or not. On/Off
can be set independently for the upper and the
lower.
Call the upper or lower using the corresponding
number (21 for Upper, 31 for Lower), then select
ON or OFF using the a Dial.
4) Other MIDI Functions
The following MIDI Functions can be set to ON or
OFF using the a Dial.
e Aftertouch
Upper . . Number 22
Lower . . Number 32
© Bender
Upper. . Number 24
Lower .. . Number 34
® Modulation
Number 25
Number 35
e
. Number 26
. Number 36
°
Number 27
. Number 37
@ Volume
Upper . Number 28
Lower .. Number 38
The Volume On/OFF can be set with the a Dial, but
selecting the MIDI Volume with the Contral Assign
will automatically set it to ON.
© System Exclusive
This message is not affected by channel setting.
Call it by assigning its Function Number 11, then
turn it on or off with the a Dial.
® Local
Upper
Lower
Number 23
. Number 33
Usually this function should be set to ON.
Local OFF separates the keyboard section from
the synthesizer section. Therefore, the keyboard
messages sent out from the MIDI OUT does not
cause the JX-10 to sound. The JX-10’s synthesizer
section is played with the messages fed itno the
MIDI IN.
* For assigning the Function Number of a MIDI
message, the a Dial can be used instead of the
Ten Keys. After pushing the MIDI then PARAM,
rotate the a Dial, and the Function shown in the
Display will change in sequence. When the
Function you wish to edit appears in the Display,
push the VALUE of the Edit Buttons, then
change value with the a Dial. However, to con-
tinue to edit other Function, be sure to push the
PARAM button, then call the Function you want
by using the a Dial.
* To cancel the MIDI function editing mode, sim-
ply push the MIDI of the Edit Buttons @.
59