■ Mixer settings for each part
Procedure
1. Press [PART]-[F2 (MIXER)].
The mixer setting page will appear.
2. Press [F1]–[F4] to select the parameter that you wish to
set.
3. Use [CURSOR] to move the cursor to the part that you
wish to set.
4. Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
VOLUME ([F1]): 0–127
Adjusts the volume.
PAN ([F2]): L15–CENTER–R15
Adjusts the left/right(pan) position of the sound. “L15” is
far left, “C” is center, “R15” is far right.
* If you have chosen headphones (Phones Only) as the output des-
tination, the sound will be located in the center regardless of this
setting.
FXSEND ([F3]): 0–127
Adjusts the effect send level.
OUTPUT ([F4]): MASTER, PHONES
Select the output destination of the sound. The sound cannot
be output from the DIRECT 1, 2, 3 outputs.
MASTER: Output from the MASTER OUT and PHONES
jacks
PHONES: Output only from the PHONES jacks
■ Muting a specific part
Procedure
1. Press [PART]-[F4 (MUTE)].
The “PART MUTE” page will appear.
2. Press [F1]–[F4] to turn muting on/off.
The [F1]–[F4] buttons correspond to Part 1, Part 2, Bass part,
and the Drum part. Muting will be switched on/off each
time you press the button.
Chapter 6. Sequencer
107
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10
To Next Page
Loading...
