● Adjusting the head tension
For these pads, adjustments are required in order to regularize the tension of the head. Also, the ten-
sion of the head may change when the pad has been used for a long period. If this occurs, use the
following procedure to make adjustments as necessary.
fig.00-025
1
Make sure that the Trigger Type (pad model name) is set either to “10A” (PD-100) or to “12A” (PD-
120).
2
Press [SETUP], then press [F1 (TRIG)], and then press [F4 (OPTION)].
3
Strike the PD-100 or PD-120 for which you wish to make settings.
The setting page for the pad that you struck will appear.
fig.00-026
4
Use [CURSOR] to move the cursor to “Head Tension Adjustment.”
5
Use [INC/DEC] or the VALUE dial to make the setting.
With a setting of “Loose” it will be adjusted at a weaker tension, and with a setting of “Tight” it will
be adjusted at a stronger tension.
For now, set this to the medium value of “Normal.”
To Next Page
Loading...
