Specify the pads that the TD-10 will use
In order for the TD-10 to accurately receive trigger signals from each pad, you must specify the type of
pad that is connected to each TRIGGER INPUT jack.
■ If you have purchased the “V-Basic Kit” or “V-Standard Kit”
Trigger settings for the V-Basic Kit or the V-Standard Kit are provided, so you can call up and select
them.
fig.00-016
1
Press [SETUP], press [F1 (TRIG)], and then press [F1 (BANK)].
2
Use [CURSOR] to move the cursor to the “BANK” number.
3
Use [INC/DEC] or the VALUE dial to make the setting.
V-Basic Kit: BANK 1 V-Standard Kit: BANK 2
If the settings have been modified and are different than the settings in the above diagram, use the Copy func-
tion to restore the factory settings (p. 137).
This completes settings for all pads of the V-Basic Kit or V-Standard Kit. If you are using a PD-100 or
PD-120, make settings for the head tension as explained on p. 31.
Once you have completed your settings, press [EXIT] enough times to get back to the “DRUM KIT” page.
To Next Page
Loading...
