Roland V-Drums TD-50X - Page 11

11
Getting Ready
Rear Panel
(Connecting Your Equipment)
A B
C
D
E
F
G
H
Mixer or
amplied speakers
MIDI devices
(external sound module, etc.)
Electronic instruments
(sampling pads, etc.)
Pads and other
triggerable
instruments
Pads and other
triggerable instruments
(connected digitally)
Footswitch Mixer
A
[
L
] switch
Turns the power on/o.
AC IN jack
Connect the included power cord.
B MIDI connectors
Connect an external MIDI device such as an external sound module.
C FOOT SW jack
You can connect a footswitch (sold separately: BOSS FS-5U, FS-6)
and use it to control various things.
D DIRECT OUTPUT (BALANCED) jacks
Connect these to your mixer etc.
Use the [SETUP] button to set which of the DIRECT OUT 1–8 jacks
that the instruments or other sounds are outputted to.
* Pin assignment of DIRECT
OUTPUT (BALANCED) jacks
E MIX IN (STEREO) jack
Connect this to an electronic instrument such as a sampling pads.
F MASTER OUT (BALANCED) jacks /
MASTER OUT (UNBALANCED) jacks
Connect this to your amplied speakers, mixer or recording
equipment.
To output in mono, connect only the L/MONO jack of the MASTER
OUT (UNBALANCED).
* Pin assignment of MASTER
OUTPUT (BALANCED) jacks
G TRIGGER IN jacks
Connect these jacks to the cymbals, toms, kick drums and so on.
* Use a stereo type (TRS) cable when connecting a digitally-trigged
pad.
H DIGITAL TRIGGER IN ports
Connect pads that support digital connection (e.g., PD-140DS, CY-
18DR, or VH-14D).