Roland V-Drums TD-50X - Customizing a Kit; Editing Instruments and Sounds

22
Performing
TIME CHECK settings
In the TIME CHECK screen, you can press the [F2] (SETUP) button to
change the pads that are evaluated and the number of measures that
are scored.
Parameter Value Explanation
Score
Species whether the score will be shown in the
screen.
OFF
Your performance will not be
scored. Only the timing will be
checked.
ON (4, 8, 16, 32
meas)
The score will be shown in the
screen. You can also specify the
number of measures you’ll practice
before being scored.
Grade
Species the strictness of scoring.
EASY Normal
HARD
Timing will be checked more
strictly.
Display 1
Display 2
In the screen, select the pad for which a timing
graph will be shown.
Gauge
LEFT BEHIND
The left side of the timing graph is
shown as BEHIND (late).
LEFT AHEAD
The left side of the timing graph is
shown as AHEAD (early).
* Press the [F3] (CLICK) button to make click settings (p. 17).
Developing Internal Timing Sense
(QUIET COUNT)
This lets you practice keeping the tempo with your body.
For the rst few measures, the click is heard at the specied volume,
but for the next few measures the click is not heard. This cycle of
several measures will continue until you stop it.
1. In the QUIET COUNT screen, press the [F5] (START)
button.
2. Strike the pad in time with the click.
5
The click will sound during the rst few measures. When you reach
the last measure during which the click will sound, the screen will
indicate “Ready..”
5
When the click stops sounding, the screen indication will change to
“Quiet.” Continue striking the pads during this time.
5
After the Quiet region, the proportion of your strikes that were
played at an accurate tempo are shown as a “%.”
3. Press the [F4] (STOP) button.
4. Press the [EXIT] button to nish.