Roland V-Drums TD-50X - Performance Techniques

13
Getting Ready
Making the Power Automatically Turn O
After a Time
(AUTO OFF)
The power to this unit will be turned o automatically after
a predetermined amount of time has passed since it was
last used for playing music, or its buttons or controls were
operated (Auto O function).
If you do not want the power to be turned o automatically, disengage
the Auto O function.
* To restore power, turn the power on again (p. 12).
1. Press the [SETUP] button.
2. Use the PAGE [UP] [DOWN] and function buttons to
select “AUTO OFF.”
The AUTO OFF screen appears.
3. Use the [-] [+] buttons or the dial to set the Auto O
function.
Value Explanation
OFF The power does not turn o automatically.
4 HOURS
When four hours have elapsed without
any pad being struck or any operation
being performed, the unit will turn o
automatically.
4. Press the [KIT] button to return to the DRUM KIT screen.
MEMO
If the AUTO OFF function is set to “4 HOURS,” the message
“WARNING: AUTO OFF, The TD-50X will turn o in 30 min.” appears
30 minutes before the power turns o.
Making Hi-Hat Settings
When using the VH-14D digital V-hi-hat or the VH-13, VH-11 or VH-10
V-hi-hats, adjust the oset on the TD-50X.
This is necessary in order to correctly detect open/close operations
and pedal movement.
Settings for the VH-14D
1. Press the [TRIGGER] button.
2. Press the PAGE [UP] button several times to display the
topmost page.
3. Press the [F4] (HI-HAT) button.
The TRIGGER HI-HAT screen appears.
* “VH-14D” is not shown as a Trig Type when the VH-14D is not
connected or if it is not assigned as the hi-hat. In this case, connect
the VH-14D and assign it as the hi-hat (p. 12).
4. Press the [F5] (OFFSET) button.
The VH OFFSET ADJUSTMENT screen appears.
5. Loosen the clutch screw of the VH-14D and let it sit on
the bottom hi-hat.
* Do NOT touch the hi-hats or the pedal.
Clutch screw
6. Press the [F5] (EXECUTE) button.
The “VH Oset” parameter is set automatically (approx. 3 seconds).
The [TRIGGER] button ashes and then remains lit.
7. Press the [KIT] button to return to the DRUM KIT screen.
Make detailed adjustments to the parameters as necessary.
&
“Data List” (PDF)