Roland V-Drums TD-50X - Applying Effects

33
Customizing the Kits
Parameter Value Explanation
Pad Maximum
Volume (*1)
-5–0
Maximum volume of each pad
This lets you decrease the
volume of the strongest hits
while preserving their nuances.
Use this to keep the volume
down while still maintaining
the nuances of the strongest
hits.
* This is available only for
pads that support digital
connection and for input
from the MIDI IN connector.
[F4] (KIT VOL) button
Kit (Kit Volume)
-INF–+6.0dB
Drum kit volume
Pedal HH
(Pedal HI-HAT
Volume)
Pedal hi-hat volume
XStick
(XStick Volume)
Cross-stick volume
HH Op/Cl Balance -5–+5
Balance between open and
close volume
Lower values decrease the
volume of the hi-hat when
played while open, relative to
the volume when played while
closed. Higher values increase
the volume of the hi-hat when
played while open, relative to
the volume when played while
closed.
(*1) Press the cursor [
H
] [
I
] buttons to switch between selecting
“Pad Minimum Volume” or “Pad Maximum Volume.”
MEMO
5
Pressing the [F5] (H & R) button to switch this on lets you make
simultaneous settings, such as both the head and the rim.
5
You can set the “Kit Volume” on the KIT SETTINGS screen (VOLUME
tab) as well.
5
The MIXER VOLUME and MIXER PAN settings can be copied (p. 45).
Applying Eects
Use the eects to change the volume (pad compressor) and tonal
character (pad equalizer) for each pad, or to set a maximum of three
eects to apply to the drum kit sound (multi-eects).
&
For details on the parameters that can be edited, refer to “Data List”
(PDF).
1. Press the [MIXER] button.
2. Press the PAGE [UP] [DOWN] buttons to display the
settings screen.
PAD EQ screen (pad equalizer)
PAD COMP screen (pad compressor)
MFX1–3 (multi-eect)
3. Edit the eect settings.
Turning the eects on/o
1. Press the [MIXER] button.
2. Press the PAGE [UP] [DOWN] buttons to display the
settings screen.
3. Press the function buttons to turn the eects on/o.
Screen Button Explanation
PAD EQ screen [F4] button Turns the pad equalizer on/o.
PAD COMP screen [F4] button
Turns the pad compressor on/
o.
MFX1–3 screen [F5] button
Turns on/o multi-eects 1–3
selected by the [R1] knob.
MEMO
You can copy the settings for the pad equalizer, pad compressor
and multi-eect (p. 45).