Roland VC-1-SC - Setting the Operation Mode; Mode Switch 5: Output Frame Rate; Mode Switches 6;7: Output Resolution; Mode Switch 8: Input Setup Level

Setting the Operation Mode
26
MODE SW 5
This species the frame rate of output.
OFF 59.94 Hz
ON 50 Hz
MODE SW 6/7
This species the output resolution.
6 OFF 7 OFF Output at SD resolution
6 ON 7 OFF Output at 1280 x 720 progressive resolution
6 OFF 7 ON Output at 1920 x 1080 interlaced resolution
6 ON 7 ON Output at 1920 x 1080 progressive resolution
MODE SW 8
This species the setup level for composite input and SD component input.
* This is valid only for NTSC input and 480i input.
OFF Used mainly in Japan
ON Used mainly in NTSC regions other than Japan
MODE SW 9
This species the type of 3G-SDI output coming out from the SDI OUT connector.
* The signal type of SDI IN is detected automatically.
OFF Output with Level A mapping structure
ON Output with Level B mapping structure
MODE SW 10
This species the control mode.
* This also enables/disables the AUTO OFF function (p. 12).
OFF Mode is controlled by switches 1–9.
ON The unit operates according to the settings in the internal memory (Set with VC-1 RCS software).