Roland VR-50HD MK II - Saving the Units Settings on a USB Flash Drive

34
Other Features
Saving the Unit’s Settings on a USB Flash Drive
You can group together the unit’s settings into a single le (.V50) and save it to a USB ash drive connected to the USB MEMORY port. You can
access the saved setting le on the USB ash drive and load it into the unit for use when needed.
NOTE
5
When using a USB ash drive for the rst time, you must
format it using this unit (p. 35).
5
Never turn o the power or remove the USB ash drive while
the message “Processing.” is shown.
5
Depending on the USB ash drive, recognition of the ash
drive might take some time.
Saving a New File
1. Press the [MENU] button
0
touch < >
0
System
<Memory>.
2. Touch USB Memory <Save As>.
3. Touch < > < > to move the cursor, and use the
[VALUE] knob to enter the le name.
<Insert> Inserts a space at the cursor location.
<Delete> Deletes the character at the cursor location.
If you want to cancel the operation, press the [EXIT] button.
4. When you have nished entering the name, press the
[ENTER] button.
The current settings are saved to the USB ash drive as a le.
5. Press the [MENU] button to close the menu screen.
Overwrite-saving
1. Press the [MENU] button
0
touch < >
0
System
<Memory>
0
USB Memory <Save>.
2. Touch to select the settings le that you want to overwrite.
If you want to cancel the operation, press the [EXIT] button.
3. Press the [ENTER] button.
The settings le is overwrite-saved.
4. Press the [MENU] button to close the menu screen.
Loading
Here’s how to load this unit’s settings that you saved on a USB ash
drive. When you load settings, the current settings are overwritten.
1. Press the [MENU] button
0
touch < >
0
System
<Memory>
0
USB Memory <Load>.
2. Touch to select the settings le that you want to recall.
If you want to cancel the operation, press the [EXIT] button.
3. Press the [ENTER] button.
The settings are loaded.
MEMO
Content that is not saved to the le
5
“Test Pattern” and “Test Tone” settings (p. 52). The unit always
starts with these “OFF.”
5
The still images loaded into the unit. Only the le names of the
still images are saved.
5
The state of the [OUTPUT FADE] button. Always unlit at startup.