Roland VR-50HD MK II - Formatting a USB Flash Drive; Renaming the Monitor Label

35
Other Features
Formatting a USB Flash Drive
The rst time that you use a USB ash drive, you must use this unit to
format it.
NOTE
5
A USB ash drive that was not formatted by this unit will not
be recognized.
5
Never turn o the power or remove the USB ash drive while
the message “Processing.” is shown.
5
When you format a USB ash drive, all data on that USB ash
drive is erased. If the drive contains important data, back it up
to your computer before you format the drive.
1. Connect the USB ash drive to the USB MEMORY port.
* Ensure that the USB ash drive is oriented
correctly, and insert it all the way into the port.
Do not use excessive force.
2. Press the [MENU] button
0
touch < >
0
System
<Memory>.
3. Touch <Format>.
A conrmation message appears.
If you want to cancel the operation, press the [EXIT] button.
4. To format the USB ash drive, press the [ENTER] button.
Formatting is executed.
5. Press the [MENU] button to close the menu screen.
Renaming the Monitor Label
You can rename the labels that are shown on the monitor for the
input/output video or still images. The label can be up to eight
characters.
1. Press the [MENU] button
0
touch < >
0
System
<Setup>.
2. Touch < >
0
Touch Panel <Label>.
3. Touch the label that you want to rename.
4. Touch < > < > to move the cursor, and use the
[VALUE] knob to enter the label name.
<Insert> Inserts a space at the cursor location.
<Delete> Deletes the character at the cursor location.
If you decide to cancel the entry, press the [EXIT] button.
5. When you have nished entering the label, press the
[ENTER] button to conrm the label name.
6. Press the [MENU] button to close the menu screen.
MEMO
You can hide the tally border and label that are shown in the
multi-view that is output from the MULTI-VIEW connector.
Use the [MENU] button
0
<
>
0
System <Setup>
0
< >
0
Touch Panel <
Label>
0
<
>
0
and set “MULTI-VIEW Label”
to “OFF.”