Roland VR-50HD MK II - Remotely Controlling a Camera

30
You can connect up to six cameras via the LAN port and remotely control them from this unit.
Remote cameras made by JVC and Panasonic are supported.
* Refer also to the owner’s manual of your camera.
Network Settings on the Camera
In order to control a camera from this unit, you need to make
network settings on the camera. You can register up to six cameras.
1. Press the [MENU] button
0
touch < >
0
Network
<Camera Control>
0
<Setup>.
2. Touch a menu item to select it, and make network
settings.
Menu item Explanation
Camera ID Selects the camera to be controlled.
Protocol
Species the camera’s protocol.
JVC camera: JVC
Panasonic camera: Panasonic
Login Name
When “PROTOCOL” is “JVC”
Touch to access a screen where you can input the
login name. Enter the log-in name needed to connect
with the camera.
Password
When “PROTOCOL” is “JVC”
Touch to access a screen where you can input the
password. Enter the password needed to connect with
the camera.
IP Address Input the camera’s IP address.
3. Press the [MENU] button to close the menu screen.
Registering Camera Settings in a Preset
Up to eight sets of settings such as camera position and focus can be
registered as presets.
A registered preset can be recalled when needed.
* Presets are saved in the camera itself.
1. Press the [MENU] button
0
< >
0
Network <Camera
Control>
0
“Camera” to select the camera ID that you
want to operate.
2. To operate camera settings, touch < >
0
and touch
the screen to select menu items.
Menu item Explanation
Positioner
Adjusts the horizontal position. (*1)
Adjusts the vertical position. (*1)
Speed
Adjusts the speed at which the camera
changes direction.
Zoom
Fast
Wide Zooms-out at high speed. (*1)
Tele Zooms-in at high speed. (*1)
Slow
Wide Zooms-out at low speed. (*1)
Tele Zooms-in at low speed. (*1)
Reset Resets the zoom position.
FOCUS
Near The focus moves closer. (*1)
Far The focal point moves farther away. (*1)
Auto
If this is “ON,” the focal point is set
automatically.
Exposure Auto
Species the exposure mode (auto/manual).
If this is on, auto mode is enabled.
TALLY Ch
Species the number of the video input to
which the camera’s video is being input.
When the camera video from this unit is the
program output, the camera’s tally light is lit.
(*1) The camera is operated while you touch the item.
Remotely Controlling a Camera