Roland VR-50HD MK II - Input Assign Screen; Transition Setup Screen

48
Menu List
Menu item Value (bold text: default value) Explanation
AUX Bus Source
Selects the video that is sent to the AUX bus.
* You can also use the AUX [1]–[PGM] buttons to select this.
Input 1–4 Video being input to Video Input 1–4
PinP Source video of the PinP layer
PinP/KEY Source video of the PinP/KEY layer
PGM Program video
Cropping
Cropping OFF, ON Switches cropping on/o.
Size H 0–128–1920 (*12) Adjusts the horizontal size. The video becomes smaller to match the size.
Size V 0–64–1080 (*12) Adjusts the vertical size. The video becomes smaller to match the size.
Orientation
(
)
Species the orientation of the cropped video.
(*12) The valid range of setting values depends on conditions such as the input/output format. In some cases, changing the value of a setting might not aect the video.
Signal Type
3G-SDI Mapping Level A, Level B Species the mapping structure of the 3G-SDI output.
HDMI PGM
HDMI, DVI-D Species the type of signal that is output from each HDMI OUT connector.HDMI AUX
HDMI MULTI-VIEW
Color Space
HDMI PGM
RGB 0-255, RGB 16-235
YCC 4:4:4, YCC 4:2:2
Species the color space that is output from each HDMI OUT connector.
HDMI AUX
HDMI MULTI-VIEW
Input Assign Screen
(Press the [INPUT ASSIGN] button, or [MENU] button0Video <Input Assign>)
Menu item Value (bold text: default value) Explanation
(Video Input 1)
SDI, HDMI, Composite
RGB/Component
Select the video source (connector name) that is input to Video Input 1–4.
* When the [SELECT] button is lit green, you can also use the STILL/INPUT SOURCE [1]–[4] buttons to
select the video source.
(Video Input 2)
(Video Input 3)
SDI, HDMI
(Video Input 4)
Transition Setup Screen
([MENU] button0Video <Transition Setup>)
Here you can make settings for video switching.
Menu item Value (bold text: default value) Explanation
Time 0–1.0–4.0sec
Species the video transition time.
* This can also be set by the [TIME] knob.
Wipe
Pattern
( )
Species the wipe pattern.
Direction Normal, Reverse, N/R Species the direction of wipe.
Border Use the following items to adjust the border added to the edge of the wipe area.
Red 0–128–255 Adjusts the red level of the border color.
Green 0–128–255 Adjusts the green level of the border color.
Blue 0–128–255 Adjusts the blue level of the border color.
Width 0–63 Adjusts the width of the border.