Important safety tips!
8
Lens protection material
To protect the projector lens from vibration during handling, the lens protection material
has been covered to the product at the time of purchase. Remove the lens protection
material before use and save it for future use. Move the lens to its original position and
cover it with the lens protection material when handling.
Lens protection material
Handling precautions
When handling the projector, hold the bottom of the projector to avoid excessive
vibration and impact. This can damage internal components and result in malfunctions.
When handling the projector, the front leg adjusters should be retracted, otherwise the
front leg adjusters may be damaged.
●Do not set up the projector outdoors. The projector is designed for indoor use only.
●Avoid setting up the projector in the following places.
●Placeswhich are subject to vibration and shocks: For example, in a vehicle such as a car.
Failure to observe this may damage internal parts or cause equipment failure.
●Places close to the sea or where corrosive gases may be present. The projector may
malfunction due to corrosion and the component life may be shortened, resulting in
malfunctions.
●Places near the air conditioning exhaust vent: Depending on the conditions of use, the
image may be affected by the high temperature air discharged from the exhaust vent or
the hot and cold air discharged from the air conditioner, and rare jitter occurs. Make sure
that the exhaust from the projector or other equipment or the air from the air conditioner
do not blow directly into the front of the projector.
●Places which are subject to sudden temperature changes: For example, near the light source
(the lamp). The service life of the light source may be shortened, or the projector may
malfunction due to deformation caused by hot air. The operating ambient temperature
of the projector should be followed.
●Places near high voltage cables or near motors: The projector may be exposed to
interference if doing so.
●Installation work such as installing the projector to the ceiling should be done by a qualified
technician or distributor. To ensure the performance and safety of the projector, when
installing it to the ceiling or high, it should be done by a qualified technician or distributor.
●Install the connection cable by a qualified technician or distributor. If the cable transmission
characteristics cannot be achieved due to improper installation, image and sound interruption
may occur.
●If there are strong radio waves from radio stations or radios around, the projector may
not function properly.If there are any facilities or equipment near the installation location
that output strong
Safety Precautions
To Next Page
Loading...
