46
Auto setup
Input Source Search
This function automatically detects the
input signal. Stop searching when the
signal is found, press buttons to
select one of the following options:
Input source search, auto keystone
correction, and auto computer adjustment
can be performed by pressing the AUTO
SETUP button on the top control panel
or the Auto Setup button on the remote
control. These function settings can be
converted as follows:
Only the last selected input source can
be checked.
If you press the INPUT button on the
top control panel or the input source
button on the remote control while
searching for an input source, the input
source search will stop and return to
the last used input signal.
The auto keystone correction function
can only correct vertical keystone
distortion, not horizontal keystone
distortion.
The auto setup function does not ensure
that the image distortion is completely
corrected. Press the keystone correction
on the remote control or select the
keystone correction in the setup menu
to make manual adjustments.
The horizontal and vertical position of
some computers can be adjusted entirely
by the auto computer adjustment function.
If the image is not correct after this
function adjustment, adjust manually.
Off........ Does not use the input source
search function.
On........ Start the input source search
function under the following
conditions:
Cancel auto computer adjustment.
Cancel the auto keystone correction
and enter the manual mode.
Disable the auto keystone correction function.
Press the auto setup in the menu
settings, Set auto vertical, keystone
adjustment to Auto and the auto keystone
correction function is turned on immediately.
Press the auto configuration in the
menu settings to set the Input Source
Search to On and the Auto Computer
Adjustment function can be turned
on immediately.
- Press the AUTO SETUP button on
the top control panel.
- Press the Auto Setup button on
the remote control.
If no display or still function is performed,
cancel it to perform an input source
search. This function is invalid when
the on-screen menu is displayed.
The auto keystone correction function
does not work when the ceiling
function in the setup menu is set to
be On.
Caution
To Next Page
Loading...
