3.3.1.3. Registering Fingerprint
①
Press [Fingerprint] button in [Add user] screen to
register.
To cance l regis trati on and move out, press [ ] button.
When the left screen is displayed, select a finger to be
registered.
※
In case of registering many fingers, already
registered finger will be displayed in blue circle ( ).
If an already registered finger is selected, the
following message will be displayed. Select Re-
register to delete the existing registered fingerprint
and try again.
②
Input fingerprint(s) referring to ‘1.7. Method to
correctly register and input fingerprint‘. Input fingerprint
2 times according to information in the screen as
follows.
When the fingerprint sensor lamp is ON along with the
message of ‘input fingerprint‘, put finger in fingerprint
input window and wait for about 2~3 seconds until
lamp OFF and then remove the finger.
$
Input the fingerprint which is just input one more
time when the message of ‘Input the same fingerprint
once again’ will be displayed.
※
For the second input of the fingerprint after the first
input, make sure that finger is removed from the
fingerprint input window before the second input.
To Next Page
Loading...
