•
Place the equipment in a dry area.
•
Do not expose or use the equipment near heat sources.
•
Place the equipment where it can be properly ventilated.
•
Do not use corrosive chemicals, solvents or harsh detergents to clean the equipment.
•
If storing the device for a long period of time, disconnect it from the power mains and put it in
a safe place, where it is not exposed to outside weather conditions.
The equipment was designed to be mechanically sturdy and
suitable for use in a workshop.
Careless use and excessive mechanical strain may compromise
its efficiency.
Safety measures:
•
Do not drop, shake or bump the equipment.
•
Do not place the equipment where it could fall into water. Avoid any contact with water.
•
Do not place any objects on the cables or service hoses.
•
Do not perform any kind of intervention that may damage the equipment.
•
Do not use the touchscreen with sharp objects or any other kind of object that may damage
it.
•
Do not access the components inside the equipment unless explicitly requested by specific
maintenance operations indicated in this manual.
The equipment was designed to be electrically safe and to work
with specific supply voltage levels.
Failure to comply with the specifications related to the power
supply may impair its efficiency.
Safety measures:
•
Do not expose the equipment to water or other liquids.
•
Do not use external batteries to power the equipment.
•
Do not use extension cords to power the equipment.
The electromagnetic compatibility tests carried out on the tool
guarantee that it can be adapted to the technologies normally
used on vehicles (e.g.: engine check, ABS, airbag, etc.).
Nevertheless, if malfunctions occur you should contact the
vehicle's dealer.
11
To Next Page
Loading...
Need help?
General