The current used during the operating phases may generate
Electromagnetic Fields (EMF) near the equipment.
Even though of low intensity, these fields may interfere with
medical prostheses, such as pacemakers.
Safety Measures:
•
Keep away from the equipment after launching the operating phases.
•
If you have a medical prosthesis (e.g.: pacemaker), check with your doctor as to the
appropriateness of using the equipment or being near it.
4.6 Device Safety
The equipment was designed in compliance with the regulations
on pressure equipment and assemblies, evaluating and
reducing the risk where present and making appropriate
considerations.
However, vibrations, pressure variations or excessive
temperatures, especially if cyclic, should be avoided.
Safety Measures:
•
During use, do not move out of the TS operating temperature range and do not exceed the
PS maximum operating pressure (see plate on the equipment).
•
Only use the refrigerant R134a.
•
Make sure you use the correct refrigerant for the model of the device you are using.
•
Make sure you use the correct refrigerant for the vehicle you are working on.
•
Connect the hoses correctly by following the colors indicated: Blue hose - LP coupler, Red
hose - HP coupler.
•
Make sure all the valves are closed before connecting the device to the A/C system or to an
external cylinder.
•
Make sure the operating phase has ended and that the valves are closed before disconnecting
the device; this should be done to avoid the refrigerant from spreading into the atmosphere.
•
It is absolutely forbidden to modify the calibration of the safety valves and the control systems.
•
Do not smoke near the device or during the operating phases.
•
Do not expose the device to direct sunlight, rain and bad weather conditions.
•
Disconnect the hoses with extreme caution; they may contain refrigerant under high pressure.
•
Make sure the couplers are not open when the hoses are placed back around the service
hose holder.
•
Do not leave the device connected to the power supply if you do not intend to use it
immediately.
The equipment was designed to be used in specific
environmental conditions.
Using the equipment in environments with temperatures and
humidity that differ from those specified may impair its
efficiency.
Safety measures:
10
To Next Page
Loading...
Need help?
General