10 HANDLING
This chapter describes the operations required to properly handle and position the equipment for
use.
10.1 Moving the Device
The equipment must be moved on its own wheels.
The equipment was specifically designed and created to lower
the center of gravity, so the heavier components were placed on
the bottom; however it was not possible to completely eliminate
the risk of tipping over.
Do not handle the equipment on excessive slopes.
Proceed as follows:
1.
Disconnect the service hoses from the vehicle's A/C system.
2.
Disconnect the power cable from the mains.
3.
Lock the refrigerant scale.
4.
Unlock the wheels (if required).
5.
Push the cart using the specific handle located on the back of the equipment.
27
To Next Page
Loading...
Need help?
General