CLEANING
* Clean Master cylinder bore, reservoir
portion and Piston with seals, with clean
Brake fluid.
Do not clean the rubber parts with petrol or any
other gasoline product
or
water. USE BRAKE
FLUID
ONLY.
ASSEMBLY
MASTER
CYLINDER
*
Assemble
the
conical
spring
(compression) with the piston. Smear the
piston, seals and cylinder bore with clean
brake fluid.
* Then assemble the piston sub-assembly
by gently pressing into the bore.
* Assemble the circlip into the groove
in
the
master cylinder. Ensure that circlip is
seated inside the groove properly.
* Assemble the Boot.
~
:
Do not use tools with sharp ends.
www.hitchcocksmotorcycles.com
To Next Page
Loading...
