FOREWORD
PREPARATION FOR SERVICE
Good preparation is very important for efficient service work. A clean work area at the start of
each job will allow you to perform the repair as easily and quickly as possible, and will reduce the
incidents of misplaced tools and parts. A motorcycle that is excessively dirty should be cleaned
before work starts. Cleaning will occasionally uncover sources of trouble. Tools, instruments and
any parts needed for the job should be gathered before work is started. Interrupting a job to
located tools
or
parts is
an
unnecessary distraction and causes needless delay. Tools required
for special service work are listed
in
Section 02.
USE
OF
GENUINE REPLACEMENT PARTS
When replacement parts are required, use only genuine Royal Enfield parts. Failure to do so
may result
in
product malfunction and possible injury to the driver and or passenger.
SERVICE BULLETINS
In
addition to the information presented
in
this Service Manual, Royal Enfield will periodically
issue Technical Service Bulletins. These Bulletins cover interim engineering changes and
supplementary information.
IMPORTANT NOTICE
All images shown are for reference to explain and need not
be
exactly the same on the model
you own. Technical specification are subject to change without prior notice.
Because of changes that may occur
in
the manufacturing process since the Service Manual was
printed, it is possible some instructions, illustrations, pictures or designs found within this manual
may differ
tom
those found on the vehicle. However the technical information found within this
manual was correct at the time it was approved for publication.
www.hitchcocksmotorcycles.com
To Next Page
Loading...
Need help?
General
