16) PROGRAMMING NOTES
If a mistake is made during programming, return to the beginning of that programming section, start
again and complete all the required steps.
─────────────────────────────────────────────
ALL PROGRAMMING IS PERFORMED IN THE PROGRAM MODE
─────────────────────────────────────────────
Explanation of flow charts:
This manual uses a flow chart system to illustrate programming procedures. Following are
explanations for the symbols used.
( ) : Parentheses indicate that an entry from the numeric keypad is necessary.
[ ] : Square Brackets indicate that depressing one of the function keys is necessary.
16-1) DATE PROGRAMMING
Enter the date in the sequence of month, day, and year and depress the #/ST/NS key.
( month ) ( day ) ( year ) - [ #/ST/NS ]
Example : ( 112017 ) - [ #/ST/NS ]
16-2) TAX RATE PROGRAMMING
TO SET THE STRAIGHT TAX RATE:
( 1-4 ) - [ Tax shift ] ...TAX NUMBER
( XX ) - ( 4 ) - [ Tax shift ] ...MAXIMUM NON TAXABLE PRICE AND STRAIGHT TAX STATUS (4).
( 0 - 99999 ) - [ Tax shift ] ...INDEX THE DESIRED TAX RATE (0 - 99.999%)
or
( 1-4 ) - [ Tax shift ] ...TAX NUMBER.
( 0 - 99999 ) - [ Amt Tend/TOTAL ] ...TAX RATE ( 0 - 99.999% )
Note: Even when in the programming sequence, you can exit the programming by pressing the
[Amt Tend/TOTAL] key.
To Next Page
