RSP STC20 - Cleaning and Lubrication of Tool Attachment

M0412-1 ver 3.0 19
Clean spring-loaded signal pins (electrical versions
only)
Clean the contact surfaces
of the spring-loaded signal
pins with a nylon brush.
NOTE!
Signal pins shall be
cleaned whenever
blackened.
3.4.4 Cleaning and lubrication of tool attachment
The following maintenance activities should be carried out on the TA every 6th month or
after 250,000 tool changes, whichever comes first.
Action
Note
Clean locking cavities
Clean the cavities of the
locking balls with a lint free
cloth.
NOTE!
It is important that this is
done or else there is a risk
that the tool attachment
jams.
Clean contact surfaces of air sealings
Wipe the contact surfaces
of the air sealings clean
with a lint free cloth.