RSP STC20 - Replacement of O-Ring

M0412-1 ver 3.0 25
4.3.3 Replacement of O-ring (STC100, STC250 and STC350 only)
Action
Note
1
Remove O-ring
Remove the O-ring on the ball holder at the
swivel tool changer with a screw driver,
2
Clean surface
Clean the surface at the O-ring location.
3
Mount new O-ring
NOTE! Make sure that the O-ring has fully
entered the groove surrounding the ball holder.
4
Apply grease
Add a small amount of grease (Magnalube-G)
on the new O-ring.