RSP STC20 - Replacement of Signal Pins

24 M0412-1 ver 3.0
4.3.2 Replacement of signal pins (electrical versions only)
Action
Note
1
Power off
Switch the power off and lock
the circuit breaker.
2
Remove signal pins
Pull out the signal pins with a
pair of pliers..
3
Replace signal pins
Fit the new signal pins by
pushing them into the sleeves.
NOTE! The signal pins must
be individually pressed fully
into the sleeves using a small
screw driver!
4
Power on
Unlock the circuit breaker and
switch the power on.