Version 1.4 Page | 64
7 Calls Operations
In this section the different types of calls and call handling will be described.
7.1 Incoming call
As the handset receives an incoming call an alerting screen will be displayed as displayed below. This
will be accompanied by a ring signal and/or a vibrating handset according to the respective settings on
the handset.
The calling party’s handset number will be shown in the display, and an additional name is displayed if
the calling party’s handset number is stored in the local phonebook.
7.1.1 Answering an Incoming Call
To answer an incoming call press the green “Off-hook” button , or press the “Loudspeaker” key
to answer the call in speaker mode.
NOTE: When “Auto answer” is set to “Automatic” an incoming call is answered automatically after one
ring signal. If “Auto answer” is set to “Any key” an incoming call can be answered by pressing any key
on the keypad, and not just the green “Off-hook” button.
7.1.2 Reject an Incoming Call
It is possible to reject an incoming call by pressing the right softkey “Reject” when receiving an
incoming call. This way the calling party will receive a busy tone, and “User busy” displayed on the
screen as shown in the picture below.
To Next Page
Loading...
