96
Managing the Access Point
Rebooting the Access Point
Rebooting the Access Point
You can use the Web interface to prompt the AP to reboot, which simply restarts the
AP without changing any of the current settings. Please note that rebooting the AP
will disrupt network communications in any currently active WLANs.
1. Go to Maintenance > Reboot/Reset. The Maintenance > Reboot/Reset page
appears.
2. Click Reboot Now. After a brief pause, you will be automatically logged out of
the AP.
Figure 47. The Maintenance > Reboot/Reset page
After approximately one minute, you should be able to log back into the AP, which
verifies that the reboot was successful. You can also check the LEDs to verify the status
of the AP.
NOTE: The 7761-CM Access Point can also be remotely reset using the OID and CLI
commands described in the ZoneFlex 7761CM Dual Band 802.11n Outdoor Access
Point with Integrated Cable Modem Installation Guide.
To Next Page
