声明：本说明书著作权归杭州睿登科技有限公司所有，未经允许任何单位或个人不得用于商业用途。
37
current setting.
M0 is the default data group when RD6006 is powered on, manually modify the
settings will automatically be record to M0 after confirmation.
1.4.2.3 Data Group Quick Storage and Call out
Data group quick store and call out operation video：https://youtu.be/eo5saPjOGpo
Press “MEM”+ keypad button 1-9, you can store the output voltage value,
output current value, over voltage protection value, over current protection value
into the corresponding data group(as shown above), then press “ENTER” to confirm,
or press the encoder potentiometer to cancel.
Press “SHIFT”+ keypad button 1-9 to quick call out the saved data (as shown
above). Press “ENTER” to confirm, or press the encoder potentiometer to cancel.
1.4.2.4 Keypad lock and unlock
Keypad lock operation video：https://youtu.be/zxpmasJyQ6Y
Press “SHIFT”+”LOCK” to lock or unlock the keyboard. And the keypad will be
automatically locked when communication starts, there will be displayed on the
top (cannot unlock manually), and the keypad will be automatically unlocked when
the connection disconnected manually, there will be displayed, the keypad will
be automatically unlocked when the connection disconnected abnormally, and the
power off button can be used when the keypad is locked.
1.4.2.5 System Setting
System setting operation video：https://youtu.be/Q9d3rIgIrOc
Press “SHIFT”+”MENU” to enter the system setting menu as shown below, press
“ENTER” to enter the menu, press direction button to select option, the option in red
is the option be chosen, rotate the encoder potentiometer to change setting.
To Next Page
Loading...
Need help?
General
