Hardware Installation and Reference Guide Installing the Access Point
13
The customized access point meets the client-specific requirements.
3.3 Precautions
The outdoor access point can be mounted on a wall or a pole with a diameter ranging from 50 mm to 70 mm
(1.97 in. to 2.76 in.). If the diameter of the pole is out of this range, please prepare a hose clamp that can hold
the pole. The thickness of the hose clamp should be at least 2.5 mm (0.10 in.). The installation site is determined
by the technical personnel who conducts a site survey.
Please make sure that the installation site meets with the following requirements in Installation Environment
Requirements and observe the following precautions:
Do not power on the access point during installation.
Install the access point in a well-ventilated location.
Do not subject the access point to high temperature.
Keep the access point away from high voltage cables.
Do not expose the access point in a thunderstorm or strong electric field.
Cut off the power switch before cleaning the access point.
Do not open the enclosure when the access point is working.
Secure the access point tightly.
3.4 Installing the Access Point
Caution
You are advised to install the access point where you can get the optimal Wi-Fi coverage.
Images are for indicative purpose only and may not represent exact equipment.
The dimensions of the mounting arm and mounting plate assembly are shown in the following figures.
Figure 3-1 Dimensions of Mounting Arm