Web-based Configuration Guide Fast Internet Access
4
a Connect the mesh repeater to power source, and wait 1-2 minutes until the status of center green
indicator changes from blinking to solid on. The mesh repeater is started.
b Press the WPS button on the primary router.
d Press the Reyee Mesh button of the mesh repeater within 2 minutes. When the three bars of the
indicator are on, the mesh repeater is connecting to the primary router. When the signal indicator is solid
white, the network connection is successful. In this situation, the default Wi-Fi disappears, and the Wi-Fi
name and password are synchronized with the primary router. Clients can connect to the amplified Wi-Fi
of the primary router to access the Internet.
e If the center dot indicator is solid red, the network connection fails. Check whether the primary router
can access the Internet. If the center dot is solid orange, the connection to the primary router fails. Move
the mesh repeater to a position closer to the primary router, remove obstacles, and repeat the preceding
operations.
⚫ Connect the Device to the Modem or the Other Router
Before performing this step, you need to connect to the Internet. Search for the wireless network with the Wi-Fi
name @Ruijie-sXXXX by using a mobile phone or laptop. The mobile phone and laptop can log in to the web
management page through a browser.
Note
XXXX in the Wi-Fi name is the last four digits of the MAC address of each device. You can find the default
wireless network name and web login address at the bottom of the device.
Caution
When an EW1200R is connected to a Reyee router, it is automatically networked and functions as a mesh
repeater without any manual configurations. If you want to use an EW1200R as a router, disable the Reyee
Mesh discovery function of the primary router.
To Next Page
Loading...
General