Web-based Configuration Guide Overview
2
1.2 System Status LED
The device is functioning properly.
The device is starting up. / The device is restoring factory settings.
The device fails to access the Wi-Fi network of the primary router.
The device is accessing the Wi-Fi network of the primary router.
The network is unreachable.
The device is accessing the Wi-Fi network of the primary router.
The signal strength is high.
The signal strength is medium.
The signal strength is low.
1. The device is set to the router mode.
2. The device fails to access the Wi-Fi network of the primary router.
Long press for more than 5s
The device restores factory settings.
Short press for less than 2s
Three functions are triggered at the same time:
1. Turn on or off the signal status LED.
2. Perform mesh networking as the Reyee primary device.
3. Establish a WPS network with other routers.
To Next Page
Loading...
General