5
Rear View Safety, 1797 Atlantic Ave., Brooklyn NY 11233
800.764.1028 sales@rearviewsafety.com
www.rearviewsafety.com
SAFETY INFORMATION
INSTALLATION
Electric shock or product malfunction may occur if this product
is installed incorrectly.
• Use this product within the voltage range specified. Failure to do so can cause
electronic shock or product malfunction.
• Take special care when cleaning the monitor.
• Make sure to firmly ax the product before use.
• If smoke or a burning smell is detected, disconnect the system immediately.
• Where the power cable may touch a metal case, cover the cable with a friction
tape. A short circuit or disconnected wire may cause a fire.
• While installing the RVS System be careful with the wire positioning in order to
avoid wire damage.
• The RVS System should only be used when the vehicle is in reverse.
• Do not watch movies or operate the monitor while driving; as it may cause an
accident.
• Do not install the monitor where it may obstruct drivers view or obstruct an air
bag device.
• Dropping the unit may cause possible mechanical failure.
• When in reverse, monitor buttons are not functional