Saftronics HPVFE User Manual

Sailer Manual HPVFE
32
Chapter 3 Programming and Parameters
Chapter 3 provides a complete listing and description of the HPVFE parameters. Parameters are programmed
(viewed/edited) using the integral keypad. Refer to Appendix B for catalog numbers.
For information on…
See page…
About Parameters
3-1
Parameter Organization
3-2
Display Group
3-3
Basic Program Group
3-8
Terminal Block Group
3-13
Communications Group
3-17
Advanced Program Group
3-19
Parameter Cross Reference – by Name
3-31
About Parameters
To configure a drive to operate in a specific way, drive parameters may have to be set. Three types of parameters
exist:
ENUM
ENUM parameters allow a selection from 2 or more items. Each item is represented by a number.
Numeric Parameters
These parameters have a single numerical value (i.e. 0.1 Volts).
Bit Parameters
Bit parameters have four individual bits associated with features or conditions. If the bit is 0, the feature is off or
the condition is false. If the bit is 1, the feature is on or the condition is true.
Some parameters are marked as follows.
=Stop drive before changing this parameter.
=32 bit parameter. Parameters marked 32 bit will have two parameter numbers when using RS485
communications and programming software.

Saftronics HPVFE Specifications

General

Brand	Saftronics
Model	HPVFE
Category	DC Drives
Language	English