Saftronics HPVFE - Start and Speed Reference Control; Start Command Source Selection; Speed Reference Source Selection

Sailer Manual HPVFE
23
Start and Speed Reference Control
The drive speed command can be obtained from a number of different sources. The source is normally
determined by P108 [Speed Reference). However, when t201 or t202 Digital Inx Sel is set to option 2, 4, 5 or 6,
and the digital input is active, t201 or t202 will overide the speed reference commanded by P108 [Speed Reference).
See the chart below for the ovenide priority.
Yes
Driw wi ll Slart and R un at Jog Spee d .
Dimclion comes from
T1m11inal 03 Din ' R un R I: V
Yes Start,Speed an d Direction COOJmands
>-- -1M COOle from ln1egral Keypad.
Yes Stal1 . Spee d and Dirnction commands
>- - + 1 come lrliTlRS485 (OS I ) port
Ru n as spocified by
P108 (Speed R et.arence ] .
Start an d Dirlldion OOOITlands oome
from P 1 06 [Start Sotrce ).
Yes
Rlll as specified by
MI 1 - A4 13 [Prese1 F req1- 3 )
Start and Dirnctioo commands ooroo
fro m P fOii [ S!Mt S o u rce].
Rill as specifie d by
P1 08 [Speed R&ltneflca].
Start an:l DiiQClion commands
comelrom P I06 [ Start Source